|
CCC Card : -
Jindal's Rectifier equipments come with an unmatched FIVE YEARS GUARANTEE against any manufacturing defect from the date of supply. We do not charge anything for the visits and spare parts during the guarantee period.
Note : While we use best quality & reputed make diodes in our equipments, however, the same are not covered under the guarantee, as diodes are not prone to aging and get damaged only due to short circuit on the output side.
Optional Add - on Attachments :
Jindal's offer following optimal Electronic attachments with rectifier equipment for different purposes :
S. No. Item
|
Application
|
Advantage
|
1. Constant Voltage Controller (CVC)
|
The CVC will automatically maintain a constant Output
voltage as per setting, irrespective of input voltage variation.
|
By using CVC, uniform quality of plating can be maintained thereby controlling excessive consumption of plating raw material at high voltage.
|
2. Constant Current Controller (CCC)
|
The CCC will automatically maintain a constant output current as per setting, irrespective of input voltage variation.
|
By using CCC, uniform quality of plating can be maintained, thereby controlling excessive consumption of plating raw material at high voltage.
|
3. DC Overload Trip System
|
The DC Overload Trip instrument will sense the signal from the output of the Rectifier and trip the main contactor in case of overshooting the set range.
|
By using DC Over Load Trip system, the diodes will be saved during any accidental short circuit in the bust bars or in the tank.
|
4. Signal Isolators
|
The Signal Isolators can be used to avoid the mill - volt drop of the Ammeter / Volfmeter signals. The Isolators can give output in milli - Volts / milli - Amps.
|
Ideal for use when the Voltmeter / Ammeter panel is kept too far from the Rectifier. These Signal Isolators are also necessary for the input signals to the PLC panel, i.e. to make the Rectifiers PLC compatible.
|
5. Zero Run Down System
|
With the help of Zero Run Down System, once the Rectifier trips of is switched off while working, it will automatically start from 0 Volts, when restarted.
|
This saves the diodes from sudden load current, thus increases the life of the equipment.
|
|
